Quick Draw Remote Control V5 Powa Beam

The latest version of the Powa Beam Quick Draw Folding Remote now also features pre-installed wiring, more secure folding mechanism and enhanced structural integrity in the mounting design.

Features:

• Pre-Installed Wires 
• Quick Release Handle folds flush with roof
• Housing machined from aircraft grade alloy
• One piece steel ball joint with internal wiring to accommodate 3 wires (The negative, a switched positive for the light, and permanent power for thermal or other device)
• Reversible long wearing, self lubricating ball joint washers
• 50^o maximum tilt, 360^o maximum rotation
• Super smooth operation
• Switch conveniently located on handle
• Adjustable tension control from inside cabin with locking ring
• Handle folds down to approx. 380mm below roof
• Compatible with Powa Beam Spotlights
• All parts are replaceable

Handle Extras:

• 70mm Stright Shaft
• 50mm Stright Shaft 
• Short folding Knuckle 

FAQ's

My remote is brand new and makes a squeaking noise, can I lubricate it?
If remote squeaks when turned left or right it is generally the rubber boot rubbing on the top shaft. You can stop this by a placing a small amount of Inox or WD40 at the top lip of the rubber boot where it meets the shaft.
The washers are made to be self lubricating therefore should not need additional oiling.
If your remote is still squeaking, try a very small amount of Inox or WD40 at the top of the ball joint. Please note too much may cause the ball shaft to slip, therefore reducing its ability to hold tension.